Hi,
I have some questions about BS1000.
My BS1000 with température sensor send value to serveur ( pachube via network) each 45 seconds .
i'd like to increase the step between 2 values
how can i do ?

If i use severals sensors, can i increase this time only for 1 sensor ?
Thanks .

Phil

Hi Phil,
You can set the inhibit time per rule: it inhibits execution of the rule for the specified amount of time.
Also you can make more than one rule, and add a condition to it like $i==<sensorid>, or $g==<group number>.
Then a rule (with its own inhibit parameter) is executed only when the condition is met: only when the measurement is from one sensor or from a specific group of sensors.
The message body and other items can remain the same for all of these rules.
Best regards
Jaap